ON
You will hear a long series
of tones followed by a two
second pause, followed by
a short series of tones.
YELLOW
Release trigger allowing it
to return to neutral position.
You must setup the ESC before running the rst time. After the initial setup, it is not required before every run.
We strongly recommend removing your tires before calibration as a safety precaution!
Start with the transmitter ON and the ESC switched OFF. Adjust the throttle trim to the center position.
Throttle Trim
Before Setup
Center
Please read through the instructions and get familiar with the procedure before starting setup. The setup process moves quickly,
and it will help you to be ready for each step.
If the LED on the speed control does not work as shown below, the speed control may not be setup properly. Repeat the setup process.
LED (Green)
Lighting
Full Throttle
Full Brake
Neutral
LED (Yellow)
Lighting
LED (Red)
Lighting
Setup
Setup Conrmation
Move trigger to full brake
position and hold until you
hear a long series of tones.
You will hear a short series
of tones followed by a two
second pause, followed by
a long series of tones.
GREEN RED YELLOW ALL
LED
RED YELLOW
En
Make sure the transmitter on.
Hold Full throttle while
switching on esc
LED
ESC Setup
5
OFF
x4
Deutsch
Français
P.14
Comments to this Manuals